![]() There's also the possibility of using the locking nut that came with the switch, but attempting to get it threaded onto the switch threads deep inside that hole would require more patience and a steadier hand than I possess. You'll need something there to prevent the switch from spinning, but maybe something like plumbers putty pressed firmly into place would work and still be removable later. If you use epoxy, let it dry overnight.Īttention: If you ever want to be able to disassemble the valve, omit the epoxy or glue on the wire side of the switch. Be careful to not put so much in, or tip the valve, so that anything gets into the upper valve area. ![]() Wipe the lampshade down with a rag to ensure it is dirt and dust free. Clamp in place and following manufacturer's recommendations on drying time. Go ahead and attach the handle onto the stem at this point and hold the wires in place so the whole switch isn't trying to rotate inside the valve.ĭrip hot glue or use your screwdriver to spread some epoxy inside the valve where the wires come out to prevent the knob from spinning inside the valve and causing the wires to twist. Wrap the metal sheets into a cylinder and secure the sides together using a clear epoxy. With the switch and stem in place, thread the bonnet nut on far enough to hold, but not so far that it starts to bind on the knob. ![]() We think the results are worth it though (via Nimi Design) 4.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |